Assembly part refer to the provided installation leaflet.
Air Valve Check
Always check the air valve carefully before inflation to ensure there is not an air leak.
If the air valve is loose, use the provided wrench to fasten the air valve following
these steps:
With one hand, hold the backside of the air valve from the inner side of the spa wall
and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is in use.
9
303021204523/14x21cm/ 54189/
欧规
AirJet SPA
说明书
/
英
SPA PUMP EQUIPOTENTIAL BONDING TERMINAL
It is recommended to arrange for a qualified electrician to connect
the spa pump to an equipotential bonding terminal using a
minimum 2.5mm
2
solid copper conductor.
NOTE:
When inflating, you will notice that air will be expelled
from the area where the air hose
connects to the pump, this is normal
for technique requirements.
NOTE:
Do not use an air
compressor to inflate the pool.
NOTE:
Do not drag the pool on rough ground as this may cause
damage to the pool liner.
NOTE:
Inflation time for reference only.
NOTE:
Pressure gauge is for inflation purpose only, and the value
of the pressure gauge is just for reference, should not be used as
a precision instrument.
NOTE:
1. Inflate the spa when the ambient temperature is above 6ºC
.
2. The water temperature should be more then 4ºC if you fill the spa pool.
