(You will need a screwdriver.)
1.
Carefully remove all components from the
package and check to ensure nothing is
damaged. If equipment is damaged,
immediately notify the retailer from where the
equipment was purchased.
2.
The sand filter should be placed on solid, level
ground, preferably a concrete slab. Position the
sand filter so the Ports and Control Valve are accessible for
operation, servicing and winterizing.
3.
The sand filter must be vertically fixed on ground or a certain
pedestal made of wood or concrete before use to prevent the sand
filter from accidental falling. Fully assembled sand filter will exceed
18 kg. The mounting holes should be 8 mm in diameter and spaced
285 mm apart. Use two bolts and nuts with a maximum of 8 mm in
diameter to fasten the sand filter to the pedestal.
LOAD POOL-GRADE FILTER SAND/FLOWCLEAR™ POLYSPHERE.
NOTE:
Use only special pool-grade filter sand, free of all limestone or clay:
#20 Silica sand 0.45-0.85 mm, approximately one 8.5 kg bag should suffice. If you do
not use the recommended size filter sand, filtering performance will be reduced and
the sand filter may damaged, thereby voiding warranty.
NOTE:
To avoid damaging the Skimmer when adding sand, pour some
water into the Bottom Tank to submerse the Skimmer on the Collector Hub.
NOTE:
Sand/Flowclear™ Polysphere not included.
NOTE:
Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace
1 kg (2.20 lbs) sand.
8
ASSEMBLY
Ø
8 mm
285 mm
#20
0.45-0.85 mm
C
C
C
C
MAX.
MIN.
