2
ASSEMBLY
Instruction for LED flashlight
Model No. #P5538
Ratings: DC3V, 0.5W, IP28(1.0m)
Warning
Do not leave a child unattended when using the flashlight.
Do not shine the light directly into eyes.
Do not expose to heat or place in contact with hot surfaces.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the product before being
charged.
Rechargeable batteries are only to be charged under adult supervision.
Do not mix old and new batteries.
Do not mix the different types of batteries
Exhausted batteries are to be removed from the flashlight.
Remove the batteries before this product is disposed of, returned or scrapped.
Batteries contain hazardous substances and are to be disposed of properly.
Please do not dispose of the batteries with general household waste.
Do not short-circuit the battery. Only use AAA batteries (not included).
Batteries are to be inserted with the correct polarity.
Completely installed before use in water.
PARTS REFERENCE OVERVIEW
Operation
1. Turn counterclockwise to remove the light cover. Remove the battery holder
and insert two “AAA” batteries (not included) into the flashlight handle.
2. Insert the Battery holder and use a coin (not included) to twist and secure
the batteries; turn the light cover clockwise in order to fasten to the flashlight
handle.
Note:
Insert the batteries with the correct polarity.
Battery replacement should be done only by adult.
3. Turn on: Turn the light cover clockwise until the LED lights up.
4. Turn off: Turn the light cover counterclockwise until the LED turns off.
Note:
Continuing to turn the light cover counterclockwise will lead to the
releasing of the light cover from the flashlight handle.
POOL INSTALLATION
Installation of the
POOL
usually takes only 10 minutes with 1 person.
1. Find solid, level ground and clear it of debris.
ATTENTION:
Do not set up the pool under cables or under trees.
2. Take the pool out of the package with care.
3. Spread out the pool and make sure the pool is right side up.
DISASSEMBLY AND CLEANING
1. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. Deflate all the air chambers, at the same time push down the wall of the
pool to release the water. Make sure release all the water in 20 minutes.
NOTE:
Draining should be done by adult.
ATTENTION:
Do not leave the drained pool outside.
3. After disassembly, use a soft cloth to clean the pool and accessories.
MAINTENANCE
Warning:
If you do not adhere to the maintenance guidelines covered herein,
your health might be at risk, especially that of your children.
1. Replace the pool water regularly; unclean water is harmful to user’s health.
2. Please contact your local retailer to obtain chemicals to treat the water in
your pool. Be sure to follow the chemical manufactuer’s instructions.
3. Proper maintenance can maximize the life of your pool.
4. See packaging for water capacity.
5. Please use environmentally friendly alkaline batteries.
Note:
Please remove the batteries if you will not be using the product for
longer than two weeks, to prevent damage to the product.
6. Keep the seal O-ring of the LED flashlight clean and lubricated. If it should
become dry, apply a small amount of pool silicone grease. Do NOT use
petroleum-based products, as these will destroy the O-ring.
REPAIRS
If a chamber is damaged, use the provided repair patch.
1. Completely deflate the product.
2. Clean and dry the damaged area.
3. Apply the provided repair patch and smooth out any air bubbles.
STORAGE
1. Make sure all water is drained from the pool. Once pool is completely dry,
put the folded pool into the package.
2. Store in a cool, dry place and out of children’s reach. Please avoid
exposing the flashlight to direct sunlight and high temperature.
4. Open the safety valves and inflate with an air pump (pump is not included
in this product), close the valves after inflation.
ATTENTION:
Do not over- inflate.
5. Begin to fill, once pool floor is slightly covered, smooth out all wrinkles.
Start at the center of pool and move to the outside.
6. Slowly fill the pool to a proper water lever, if there is a fill line, reach but do
not exceed the fill line on the pool's interior. DO NOT OVERFILL as this
could cause the pool to collapse.
ATTENTION:
Do not leave pool unattended while filling with water.
NOTE:
All drawings for illustration purpose only. May not reflect actual
product. Not to scale.
7. Place the stencil on the glow in the dark floor to draw underwater with the
LED flashlights or enjoy drawing freehand. The lines and designs left by the
LED pens will fade within minutes. Experiment with shapes, speed, and
distance from the material to create unique Underwater Glow Art!
www.bestwaycorp.com
AAA battery
(Not included)
Flashlight handle
Light cover
Battery holder
Seal O-ring
S-S-004766
Proper water lever
Bestway (USA) Inc.
3411 E. Harbour Drive, Phoenix, Arizona 85034,
United States of America
Tel: 1 480 838 3888
Fax: 1 480 304 3349
E-mail: [email protected]
