Section 1
P7 - 54922 Rev. D 0618
Installation Instructions - TREKTOP NX GLIDE 2-Door
© 2018 Bestop, Inc.
Hardware
Install Bow Mount Brackets
Step 1
529.83
Bow Mount Screw
Qty. 2 per side
Part # 308.64
Right Side
Bow Mount Bracket
Qty. 1 per side
Part # 529.83 - Left
Part # 529.84 - Right
Step 2
Step 1
Step 2
Unzip the protective covers on the front sport
bar down-tubes and locate the two threaded
holes on the side of each sport bar down-tube.
Screw the Right Bow-Mount Bracket #529.84
to the right-side sport bar down-tube using
two (2) Bow-Mount Screws #308.64.
Screw the Left Bow-Mount Bracket #529.83 to
the left-side sport bar down-tube using two (2)
Bow-Mount Screws #308.64.
Locate the Pin Point Bracket #539.20 over the
existing hole in the rear downtube of the sport
bar. Make sure the Pin Point Bracket wraps
around the outside of the sport bar.
Fasten the Pin Point Bracket to the sport bar
using one (1) Button Head Socket Screw #538.99,
two (2) 1/4” Flat Washers #538.71, one (1) Rubber
Tube #544.58, and one (1) Press-In Nut #538.97
per side.
Make sure that the Press-In Nut has the ridged
side facing the Rubber Tube.
Tighten the Button Head Socket Screw to firmly
seat the Pin Point Bracket to the sport bar, and
replace the sport bar cover.
Rubber Tube
Part #544.58
Qty. 2
1/4” Flat Washer
Part #538.71
Qty. 4
Press-In Nut
Part #538.97
Qty. 2
Pin-Point Bracket
Part #539.20
Qty. 2
Right Side
529.84 308.64
539.20 538.97 544.58 538.71
Button Head
Socket Cap Screw
Part #538.99
Qty. 2
Page 7
