TrekStep Side-Mount™ – Installation Instructions
Rev. A 0312
75407 / 75408 pg. 6
If Cross Bar Was Not Installed in Step 4
Put a drop of Loctite on the threads of two (2) M10-
1.5 x 45mm Hex Head Screws.
Place the Cross Bar Mount under the Frame Mount
Foot. Thread one M10-1.5 x 45mm Hex Head
Screw with an M10 Split Lock Washer through both
brackets into the Linkage. Thread the other M10-
1.5 x 45mm Hex Head Screw with M10 Split Lock
Washer through the Cross Bar Mount and both
brackets into the Linkage.
Install Cross Bar and Linkage
Make sure to mount the Linkage
Assembly to the holes toward the outside
of the Frame Mount Foot.
Linkage
Assembly
Cross Bar
Mount
Adjustable
Side Mount
Frame
Mount Foot
M10-1.5 x 45mm
Hex Head Screws
with M10 Split
Lock Washers
Adjust the screw on the Cross Bar until the frame
is sandwiched between the nuts. Tighten the screw
against the frame and tighten both nuts against the
Cross Bar.
Once the screw is tight against the frame, loosen
the nuts and retate the screw another 1/4" for
correct pressure on the mount.
Secure Cross Bar
Tighten
around frame
Tighten
around frame
