HighRock 4x4
™
Rocker Trim Installation Instructions
Rev. E 0709
42950 pg. 3
Once the adhesive on the Rocker Trim makes contact with the rocker
panel, you have 10 seconds to adjust the position of the Trim.
Peel all the backing tape off the adhesive on the Rocker Trim.
Use two (2) of the M6 x 20 Flange Bolts to help align the holes in the Rocker
Trim with the holes in the panel and place the Trim against the panel. Push the
Trim snug against the vehicle. When the Rocker Trim is in the proper position
apply fi rm pressure.
Install Rocker Trim
Install an M6 x 20 Flange Bolt in the two holes where the original bolts were
removed to secure the Rocker Trim to the rocker panel. Then install an M6 x
20 Flange Bolt with an M6 Flat Washer and an M6 Locking Nut in each of the
remaining holes.
Repeat steps 1 – 5 on the other side of the vehicle.
Secure Rocker Trim
Clean Door Handle Recess
Clean the door handle recess with a 50/50 solution of water and alcohol and a
soft cloth to remove any grease or dirt.
Locate the position of the adhesive strips on the back of the Door Handle Re-
cess Guard. Wipe the areas of the door handle recess that correspond to these
locations with the Primer Wipe in the parts kit.
Install Door Handle Recess Guard
Peel all the backing tape off the adhesive
on the Door Handle Recess Guard.
Place the Door Handle Recess Guard in
the door handle recess and push it snug
against the vehicle. When the guard is in
the proper position apply fi rm pressure.
Repeat for the remaining doors and the
tailgate.
The adhesive requires 24 hours to fully set and bond to the vehicle.
Peel Backing Tape off Adhesive
Once Rocker Trim is in
place apply fi rm pressure
Clean Recess with Alcohol / Water
Solution then Primer
Door Handle
Recess Guard
If you are installing the Rocker Trim on a 2 Door Vehicle, you will not
use two (2) of the Bolt, Washer, Nut assemblies on each side of the
vehicle so you will have four (4) M6 x 20 Flange Bolts, four (4) M6 Washers and
four (4) M6 Locking Nuts left over.
Install M6 x 20
Flange Bolts Only
Install M6 x 20
Flange Bolts, M6
Flat Washers and
M6 Locking Nuts
