Rev. B 1112
54820 pg. 4
Supertop NX Twill Installation Instructions
Mount Header Assembly to
Pivot Bracket
Mount Rear Bow Assembly
to Pivot Bracket
Secure Stay Pad to Rear Bow
Install the Side Bow Pivot Knuckles onto the upper
flange of the Pivot Bracket. Align the knuckle with
the bracket and snap it into place.
For 97 to 02 vehicles equipped with
factory installed Pivot Brackets, replace
with new Bracket from Kit for proper fit.
Padded Sport
Bar Cover
Side Bow Pivot
Knuckle
Driver’s Side Shown
Pivot
Bracket
Install the Rear Bow Pivot Knuckle Assemblies
onto the lower flange of the Pivot Bracket. Align
the knuckle with the bracket and snap it into place.
If you have a new top, install the Rear Bow Pivot
in the front hole.
Padded Sport
Bar Cover
Driver’s Side Shown
Rear Bow
Pivot
Knuckle
Rotate the front bow assembly forward, laying the
header on top of the windshield. Raise the Rear Bow
and pull the fabric Stay Pad attached to the Center
Bow straight back to the Rear Bow, without twisting.
Align the holes in the Stay Pad with the holes in the
corner of the Rear Bow. Install #8 x 1/2" Pan Head
Washer Screws in the holes on each side.
Sport Bar
#8 x 1/2" Pan
Head Washer
Screws
If your vehicle has molded seals on the belt rail,
remove them by pulling up on the plastic rivet.
Locate the left and right Door Surrounds. Insert the
pin in the bottom of the Door Surround into the hole
in the belt rail behind the door.
Install Door Surrounds
Insert Pin into
hole in belt rail
Driver’s Side
Door Surround
Molded Seal
Plastic Rivet
Press the channels along the top of the Door
Surround around the horizontal sport bar, above
the door opening. Insert two Knobs into the Door
Surround and tighten them down.
Channels
View from inside above Driver’s Side
Install Door Surround Knobs
Knobs
Door Surround
