0300 Rev. A
51256 pg 3
Step Two
Disconnect the Cable Release.
Lift the seat up slightly to allow access to the
cable. Lift up on the plastic tab to pull the cable off
the mounting bracket, rotate the cable up 90
°
and
pull the end of the cable out of the hole.
Remove the seat from the vehicle.
Adapter Brackets
Seat Cushion
(Front)
Step Three
Install the Adapter Brackets on the Replacement Seat.
Orient the brackets so that the raised pads are toward the outside
of the seat and the lips are toward the front and rear edges.
Place the rear bracket on the seat bottom so that the holes in the
bracket line up with the front of the three holes in the bottom of
the seat. Install two (2) of the M8-1.25x25 Bolts that came with
the seat in the bracket.
Place the front bracket on the seat bottom so that the holes in the
bracket line up with the rear of the two holes in the bottom of the
seat. Install two (2) of the M8-1.25x25 Bolts that came with the
seat in the bracket.
Release End of
Cable from Hole
Pull Up on
Plastic Tab
Select the rear
of the front
holes in seat
Seat Cushion
(Front)
Hole Pattern
Your new Bestop seat has two (2) mounting holes on
each side of the front and three (3) holes on each side
of the rear. This allows tracks from various Jeep models
to be used with the Bestop seat.
Select front of the rear
holes in seat
Rear
Pads toward
Outside of Seat
