Section 2
Remove Seatback Tilt Levers
P4 - 29283 - Rev. D 1115
© 2015 Bestop, Inc.
Page 4
Step 1
Step 2
Installation Instructions - Seat Covers, Front Kit
Remove the driver side seatback tilt lever by
using a finger to lift and pull the top spring
clip wire up, and push toward the front of the
seat to unlock the lever from the shaft.
Repeat this procedure on the passenger
seat. Note that the spring clip open end
faces the rear of the vehicle on both the
driver and passenger sides of the vehicle.
Step 1
Once the spring clip is in the unlocked position,
pull the lever straight off the shaft. After remov-
ing the lever from the shaft, push the spring clip
back into the locked position, and set the lever
aside for now.
Repeat this procedure on the passenger seat.
Note that the passenger seat in 2-door vehicles
has one 2-arm lever, which removes the same
way as the single-arm levers in 4-door vehicles.
WARNING
to preserve airbag functionality,
you MUST remove the seatback tilt levers
before placing the seat covers over the seats.
Step 2
2-Door
Passenger side shown
Note:
The retaining clip should
remain attached to
the seatback tilt lever.
