Service and Maintenance
Key Combinator Service Manual
3–13
6. With the key carriage in place, install the rear stop plate with the
two fastener screws onto the back of the key carriage. Secure the
screws using a 1/8
″
Allen wrench.
7. Calibrate a key to make sure the new key carriage is properly
installed (
Replacing the
operating lever
To remove the operating lever:
1. Make sure that the key carriage is pushed completely into the key
combinator housing.
2. Using a 5/32
″
Allen wrench, remove the two front screws on the
operating lever frame. Save the screws.
3. Pull down the operating lever so that it rests against the rubber
bumper on its own. See
Figure 3.11
Depressing the key carriage plungers
Plungers
Rear view of combinator
