Bertazzoni REF BMB Series, Installation And Use Manual

Page: 14 / 60

14
5. OPERATING THE APPLIANCE
5.6 Door Bins
To remove a door bin, hold it from the bottom, lift it
and slide it out. Please see the figure.
To adjust the height of a door bin, press and hold
the buttons at the right and left sides to adjust the
bin to the desired height without having to remove
it. To remove the adjustable door bin, press and
hold the buttons, lift the bin completely and pull it
towards yourself. To reinstall the door bin, position
it in its place on the door and press the buttons to
slide it downwards. Please see the figure.
5.7 Glass Shelves
The height of the glass shelves can be adjusted
manually using the rear hangers. Holding a shelf
from the bottom, lift the front part and raise it to
an angled position; the tabs on the hangers will be
released and the glass shelf will move up and down.
To remove a shelf
- Hold the front of the shelf, then gently lift up and
slide it out.
To reinsert
- Hold the shelf at an angle so that the front is
higher than the back, then insert the top hook into
the top shelf notch you wish to use.
- Lower the front gently.
Note
To prevent breakage or scratching the
interior of the fridge, use care when
handling glass shelves.
WARNING
Glass shelves must be unloaded before
moving.
WARNING
You must wait for the glass shelves to reach
room temperature before immersing them
in water for cleaning.
WARNING
The door may not close if the door bins are
positioned at the same level as the glass
shelves. After placing the shelves, make
sure that the door can close properly.
5.8 Refrigerator Drawers
To remove a drawer
- Pull out the drawer until it stops.
- Gently unclip the front section of the drawer, then
pull it out completely.
To install a drawer
- Pull the rails as far forward as they will go.
- Align the gaps at the rear corners of the drawer
with the components located at the rear ends of
the rails.
- Push the drawer slowly down until you feel it clip
onto the rails at the front.
Note
Make sure that the components on the
right- and left-hand sides of the rails are
firmly secured when installing the drawer.