16
4) Remove your fingers from the touch control, then push again on touch [ 0/I ]
during few seconds, until blinking [ E ] symbols appear.
5) Wait until [ E ] symbols stop blinking.
6) After few seconds, [ E ] are automatically transformed in [ C ]. The existing setup
has been cancelled.
VI) Second step : new setup
1) Take a ferromagnetical pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ C ] display
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected cooking zone is now
configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.
•
If [ E 4 ] displaying remains, please call the customer care
The hob or the cooking zone doesn’t start-up:
•
The hob is badly connected on the electrical network.
•
The protection fuse cut-off.
•
The looking function is activated.
•
The sensitive keys are covered of grease or water.
•
An object is put on a key.
The control panel displays [ U ]:
•
There is no pan on the cooking zone.
•
The pan is not compatible with induction.
•
The bottom diameter of the pan is too small.
The control panel displays [ E ]:
•
Disconnect and replug the hob.
•
Call the After-sales Service.
One or all cooking zone cut-off:
•
The safety system functioned.
•
You forgot to cut-off the cooking zone for a long time.
•
One or more sensitive keys are covered.
•
The pan is empty and its bottom overheated.
•
The hob also has an automatic reduction of power level and breaking Automatic overheating
Continuous ventilation after cutting off the hob:
•
This is not a failure, the fan continuous to protect the electronic device.
•
The fan cooling stops automatically.
