Bertazzoni KPH XT Series, Installation And User Manual, Page: 12 / 40

- 12 -
D =
SPEED II
E =
SPEED III
F =
AUTOMATIC STOP TIMER - 15 minutes
(*)
Your appliance has the
INTENSIVE
speed function, from speed THREE, press key
E
for 2
seconds and it will be activated for 6 minutes after which it will return to the previously set
speed. When the function is active the LED flashes. To interrupt it before the 10 minutes
have elapsed, press key
E
again.
• Function Clean air
By pressing key
F
for two seconds (with the hood switched off) the “
clean air
” function is
activated. This function switches the appliance on for ten minutes every hour at the first
speed. As soon as this function is activated the motor starts up at the first speed for ten
minutes. During this time key
F
and key
C
must flash at the same time. After ten minutes
the motor switches off and the LED of key
F
remains switched on with a fixed light until
the motor starts up again at the first speed after fifty minutes and keys
F
and
C
start to
flash again for ten minutes and so on. By pressing any key for the exclusion of the hood
light the hood will return immediately to its normal functioning (e.g. if key
D
is pressed
the “
clean air
” function is deactivated and the motor moves to the 2nd speed straight
away. By pressing key
B
the function is deactivated).
• Function Timer
(*)
The “
AUTOMATIC STOP TIMER
” delays stopping of the hood, which will continue
functioning for 15 minutes at the operating speed set at the time this function is activated.
• Anti-grease/active charcoal filters saturation:
- When the
A
key flashes with a
2 second
frequency the anti-grease filters must be washed.
- When the
A
key flashes with a
0.5 second
frequency the active carbon filters must be
replaced or washed depending on the type of filter.
Once the clean filter has been put back one must reset the electronic memory by pressing
the
A
key for approximately
5 seconds
until it stops flashing.