EN
2
26
INSTALLATION
Fitting the Hood canopy
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of the wall unit.
• Create an opening in the bottom of the wall
unit, as shown.
• Insert the hood until the side supports snap
into place.
• Fasten using the 10 screws
12a
provided.
• Lock in position by tightening the screws
Vf
from underneath the hood.
• Open the suction panel by turning
the specific knob.
• Disconnect the panel from the hood
canopy by sliding the fixing pin
lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 screws
12f
, re-
connect the wires to the
Commands and Light, re-
place the metal grease fil-
ter and the Panel.
260
13
495 - 675 - 835
Summary of Contents for KIN52MOD1XC
Page 103: ......
