Bernini Rechargeable Garden Fountain, Owner'S Manual

Page: 27 / 40

|21 Remember if you need help contact Customer Care: 0203 617 1773
Step 1: Attach the Dancing
Water Attachment to the water
outlet in the center of the Floral
Plate by pressing down onto the
water pump tube.
Dancing Water Attachment Installation
Before installing The Dancing Water Attachment to your fountain, make sure that the Bird
Finial is not attached.
Dancing Water
Attachment
To install the Bird Finial you will need to use the clear extension
tube included with your Bernini™ Fountain.
Before installing the extension tube,
pull the two ends of the
extension tube apart to about 9 inches (22.8cm).
Bird Finial Installation
Step 2: Attach the Extension
Tube to the water pump tube
outlet in the middle of the Floral
Plate.
Step 1: Remove the silicone
ring from the top of the exten-
sion tube.
Step 3: Put the Finial over the
Extension Tube. Be careful to keep
the tube centered in the hole at the
top of the Finial.
Enjoy your Dancing Water
Attachment.
NOTE: If the water spray nozzles need adjustment adjust the water spray nozzles according
to the “Water Spray Tip Alignment and Adjustment” section of this manual.
Warning: Dancing Water Attachment may cause water to splash slightly around your
fountain. If using attachment, be sure to place your fountain accordingly as to not damage
anything in the surrounding area..
NOTE: If needed, use sand
paper or file to take off any
ridges of resin to allow tip to go
through the hole Finial easily.