O W N E R S M A N U A L
Figure 1
Figure 2
Figure 3
Assembly Of Bird Feeder:
6.
STEP
Figure 4
Figure 6
Top Hieght
Adjustment
Bottom Hieght
Adjustment
Top Height
Adjustment
Bottom Height
Adjustment
Figure 7
Top Height
Adjustment
Bottom Height
Adjustment
Top Height
Adjustment
Bottom Height
Adjustment
Figure 5
Figure 8
Figure 9
Figure 11
Figure 10
Figure 13
Note: Be sure to place the Base of your fountain on a flat, firm surface. Insert Inner Water Bowl (Figure 1-3). Insert the fully assembled Fountain Tower into the center of the Inner
Water Bowl. There are two height options for the fountain (See Diagram 1a, Figure 4-5). To lower the height, align the feet of the Fountain Base to the bottom of the Inner Water
Bowl. To raise the Fountain height, align the feet to the raised step on the Inner Bowl. Make sure the Fountain Tower is secure before proceeding to the next step.
Note: at the botom of each height adjustment there is a slight indentation, this indentation is a designed in feature that holds the Fountain Tower snug in the Inner Bowl and
keeps the Fountain Tower steady in the event of high winds or spritied bird activity. When installing the Fountain Tower into the Inner Bowl ensure that the Fountain Tower is
pushed all the way down into the Inner Bowl.
Fill Inner Water Bowl with water until it reaches the minimum water level ring on the Fountain Tower (see Diagram 1a and Figure 8). Add bird seed to the Bottom Bowl (Figure 9).
Do not remove the Inner Water Bowl while there is bird seed in the Bottom Bowl (Figure 10). Insert the Wire Cable into the hole located on the side of the Bottom Bowl.
Thread the other end of the Wire Cable through the loop and connect it to the Hook (Figure 11-12). Repeat this step for the other two Wire Cables (Figure 13).
Figure 12
Maria 2-in-1 Bird Feeder & Fountain
TM
