Bernini Amore Hybrid Fountain, Bird Feeder & Planter, Owner'S Manual, Page: 29 / 32

Remember if you need help contact Customer Care: 1+ (619) 449-2392 |23
Troubleshooting Guide
PROBLEM SOLUTION
Fountain is not working
Charge battery for recommended time (Refer to Recharging your Battery) battery has
been charged and still will not hold a charge it may need to be replaced.
Lights or Pump
not working
Check that battery is fully charged: See charging battery section.
Make sure battery has been charged. Check that the connection port cables are
secure.
Water Not Flowing
Prime Pump as instructed. (Refer to priming the water pump)
Add Water
Check to see that pump tubes are connected
Check to see that the pump and pump tubes are clear of debris.
Loud Pump
Prime Pump as instructed. (Refer to priming the water pump).
Check water level. Ensure pump free of debris.
A/B/C/D Switch
not working
Make sure battery has been charged.
Check that the connection port cables are secure. If secure disconnect battery and
reconnect.
Fountain Settings
not working
Make sure battery has been charged.
Check that the connection port cables are secure. If secure disconnect battery and
reconnect To clear settings.
Water Pump Connection
If your Bernini™ Fountain did not come with the Water Pump already connected to
the tube inside of the Fountain Bowl or if the Water Pump gets disconnected from the
Fountain Tier, use these instructions to reconnect your Water Pump.
Before beginning, remove any
finials that may be installed in the
fountain bowl.
Step 1:
Unlock the Fountain Tier
by turning it a quarter turn counter
clockwise.
Step 2: Rest the Fountain Tier on its
side in the large bowl.
Step 3: Connect the male outlet on
the top of the water pump to the tube
inside of the Fountain Tier. Make sure
this connection is snug.
Then reassemble the Fountain Tier
with the instructions found in the
Assembly Section of this manual.