1
Yuno tables will require a small amount of field assembly. The Yuno tables will involve installation of the leg assembly, power infeed wire
management clip, and the ganging brackets.
Read the following instructions for installation of the Yuno leg assembly and power infeed wire management clip. The following
installation instructions show a yuno table with power. For assembly of yuno tables without power follow steps one and two,
excluding the power infeed wire management clip installation.
Begin by carefully removing all components from the box, placing the table top face down on a clean, protected surface.
Yuno table tops will come pre-assembled with crossmember attachment bar, power modules (wiring pre-assembled) and
felt shroud.
Yuno tables will come with the following mechanical fasteners that are
required for leg and power infeed wire clip installation:
A torx T30 bit will be required for
installation
.
After securing the legs to both the table top and crossmember assembly, a customer
assembling a powered yuno table will attach the power infeed wire management clips
using screw (C). The illustrations below are for a right hand power infeed table, for a
left hand power infeed mirror the illustration.
Right hand facing starter table
Right hand facing add-on table
Yuno leg assemblies are unique in that they can be placed on either
end of the table top.
Attach each leg assembly to the
crossmember using screw (B) and to
the table top using screw (A).
Leg Installation Instructions
leg installation instructions
yuno installation instructions
1
2
3
(A)
(A)
(x12)
(B)
(B)
(x4)
(C)
(D)
(C)
(x2)
(x2)
