Berner BHWKTD3.5, Manual, Page: 16 / 44

Page 15 Of 44 17.07.2014
Ver. 3.6 © Bernese cooking systems 2018
Make sure that any plug you are using is properly wired:
Commissioning
Assembly
The inductiongeräte are equipped with a power cable. They must be connected to a wall socket
or junction box. The electrical installations must be carried out by approved installers in
compliance with specific national and local regulations. The installers are responsible for the
correct design and installation in accordance with the safety regulations. The warning and type
plates must be strictly followed.
Check and make sure that the voltage of the mains current and the device (type plate) match.
When installing this appliance in the immediate vicinity of a wall, partition walls, kitchen
furniture, decorative cladding, etc., it is recommended that these are not made of combustible
material; otherwise, they must be clad in suitable non-combustible, thermally insulating
material, and the fire protection regulations must be observed with the most care!
The inductiongerät must be in a clean, straight surface (table, combination, etc.) ebuilt up and
stand by its final destination. It must be installed in such a way that it cannot be moved. The
"installation requirements" must be met.
Remove all items from the heating zone. Check that the heating zone is neither split nor broken.
If you stop commissioning immediately, if the heating zone is split or broken, turn off the
deviceimmediately.
Turn the power knob to the OFF position(0) before
Connect inductiongerät to the power grid.
Devices on and off switch
Position OFF:Position ON:
'0' points to the mark ()'I' points to the mark ().
οο
Power control with potentiometer
With the potentiometer, the power is infinitelyadjustable.
The knob can be rotated via the 0 position. This means that a quick changeover
from the low to the high power level and vice versa.
Elements Description Function
Rotary switch
0 position
From
Rotary switch
Range α40° -320°
Power level 1-9
For the electrical connection of the device, the legal
Regulations of the respective country!
Attention
Incorrect voltage can cause the
Damage induction device
Attention
The electrical connections must be carried
out by a specialist.