20
ENGLISH
Battery pack:
Charge the battery pack before use (1).
If performance diminishes, recharge the battery pack.
The ideal storage temperature is between 10°C and 30°C. The permissible storage temperature
is between 0°C and 50°C.
"Li-Power" li-ion battery packs
have a capacity and signal indicator: (6)
Press the button (5), the LEDs indicate the charge level.
If one LED is flashing, the battery pack is almost flat and must be recharged.
Handling
Charging battery pack:
Push the battery pack completely to the stop on the sliding seat (2).
The operating indicator (3) flashes.
Conservation charge:
Once the charging process has finished, the battery charger automatically switches to conserva-
tion mode.
The battery pack can remain in the battery charger and is therefore always ready for use.
The operating display (3) lights up continuously.
Fault:
●
Warning display (4) lights up continuously.
Battery pack is not charged. Temperature too high/ too low. When the temperature of the battery
pack is between 0 °C and 50 °C, the charging process begins automatically.
●
Warning display (4) flashes.
Battery pack is defective. Remove the battery pack immediately from the charger.
The battery pack was not pushed correctly onto the sliding seat (2).
5
Care and Maintenance
BACFP Mini:
Remove the battery prior to carrying out any work on the machine.
Check that the press jaws are fully functional. Damaged press jaws must not be used and must
be sent to an authorised Berner repair shop.
Check that the press jaw and drive rolls move freely.
Check the bolt for signs of damage at regular intervals. Have damaged bolts replaced by an au-
thorised Berner repair shop.
Clean and grease the drive rolls, the bolt and press jaws when you have finished work.
Use only high quality pressing or ball bearing grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work must be carried out by an authorised Berner
repair shop.
If the seal is damaged the warranty will be null and void.
After 40.000 pressing cycles or 2 years have the machine serviced by an authorised Berner
workshop.
When dispatching the machine ensure that it is packed in its carrying case completely with bat-
tery and charger in the carry case only.
Electro-hydraulic machine does not exceed 3 hours in a -5° C / 23°F storage.
