Step 2
Step 3
Begin by fastening the Umbrella Knobs to the
umbrella holder by turning them into the pre-
drilled holes. Next fasten the small cross supports
with the umbrella holder to the center base
assembly using 3" Buglehead Screws.
Place 2nd base assembly in the correct position
and fasten to table frame using 1/4"x2" Bolts and
1/4" Flange Nuts as shown. Next ensure the short
cross pieces are correctly positioned against the
center base and fasten using 3" Buglehead Screws.
3" Buglehead Screws
Umbrella Knob
5/8" Panhead Screws
1-1/2" Buglehead
Screws
Fasten 1 completed base assembly to the table frame as
shown by using 1/4x2" Bolts and 1/4" Flange Nuts.
1/4"x2" Bolts
Step 4
1/4" Flange Nuts
1/4"x2" Bolts
1/4" Flange Nuts
3" Buglehead Screws
Step 5
Start by placing a table brace against the bottom
of the table top and against the inside of a base
leg as shown. Fasten the brace against the leg
using 1, 1-1/2" Buglehead Screw. Next fasten the
aluminum piece against the top using 2, 5/8"
Panhead Screws.
Note: The aluminum piece that
is fastened aginst the brace should be placed
against the table top.
Step 2
Step 5
Step 4
Bolts
Step 4
Screws
Umbrella Knob
Step 3
Screws
