High protection against ambient light: To prevent the motion detector from switching to Night
mode is there is brief shadow or Day mode if there is brief light, the Day/Night and Night/Day
switchover takes place only after 10 seconds.
Behaviour in case of a mains failure
-
Less than 0.2 seconds: the old switching position is restored after mains return.
-
0.2 seconds to approx. 2 seconds: when the power returns, the lighting is switched on
again for the run-on time.
-
Longer than 2 seconds: when the power returns, the motion detector carries out a self test
for approx. 90 seconds. The lighting is switched on during the self test. Then the lighting
switches off briefly, and then on again for the length of the run-on time.
i
In the Continuous on and Continuous off operating modes, the light is switched on or off
after the self test.
i
A power failure of longer than 2 seconds causes the loss of the switch-on brightness and
the brightness threshold, saved via the Teach function.
4 Operation
Switch on the light via extension
A 2-wire extension or an installation button is connected.
o
Press button for less than 0,4 seconds.
The Light is switched on independently of the brightness for the run-on time.
i
If the run-on time setting dial (5) is set to
M
, Short-time operation, then the light is
switched on for approx. 0.5 seconds, even if the button is pressed for longer.
Switch light on with minimum brightness
Motion detector cover is combined with a dimmer insert.
A 2-wire extension is connected.
Light is switched off
o
Press button at bottom for longer than 0.4 seconds.
Light is switched on at minimum brightness and stays at this brightness for as long as
motion is detected.
Operate with 2-wire extension
Motion detector cover is combined with a dimmer insert.
Light is switched on.
o
Press top button for a long time.
The light gets brighter up to maximum brightness.
o
Long press on bottom of button.
Light gets darker to minimum brightness.
i
Manual switch-on is not possible.
Save switch-on brightness
The light is switched to this brightness value on each switch-on. In the as-delivered state, the
switch-on brightness is set to the maximum brightness.
Motion detector cover is combined with a dimmer insert.
A 2-wire extension is connected.
o
Set light to the required brightness.
o
Press the extension for at least 3 seconds.
For confirmation the lighting switches off briefly and then on again to the saved switch-on
brightness.
i
The saved switch-on brightness is deleted after a power failure.
Seite 3/10
22.07.2010
82540231
97-82640-201
BLC
BLC motion detector comfort 1.1 m
