Docking station
Page 4 /5
97-09895-000
02/2011
Cut the silicon tubes provided to the appropriate length and slip them over the loudspeaker
cable.
Attach the loudspeaker to the terminals (figure 2, 12).
Set operating mode
Stereo
or
Mono
if necessary by means of changeover switch
(figure 2, 13).
L
L
If just one loudspeaker or single-channel audio device is connected, the mono mode is
recommended. On the
Mono
switch position there is a mono sum signal at the outputs.
Connecting external audio device flush-mounted Radio
Connect external device to the terminals
Line out
(figure 2, 10). Use shielded cables for
interference-free audio transmission. Connect the shield to the terminal according to the
terminal labelling.
5.2 Assembly of the device
(14)
(15)
(16)
(17)
(18)
(19)
(20)
Figure 3: Installation
The insert is connected and the operating mode (
Stereo/Mono
) set.
Put the insert (figure 3, 14) into the flush-mounted box correctly positioned and screw
together with the screws provided.
Attach frame (figure 3, 15) of the appropriate switch range and centre plate of the docking
station (figure 3, 16). Snap centre plate onto the mounting piece (figure 3, 20).
Attach the device holder (figure 3, 17) to the support bracket (figure 3, 19) of the insert and
carefully insert the contact pins into the socket on the insert without bending the contact
pins.
Screw the device holder and the support brackets together through the screw holes at the
bottom on the insert (figure 3, 19) using the screws provided M3 (figure 3, 18).
6 Appendix
6.1 Technical Data
Operating voltage
230 V AC, 50/60 Hz
Mini USB charging socket
Rated voltage
5 V DC
Rated current
max. 0.8 A
Power consumption at rated output power
6 VA
Standby
0.5 VA
Output power
1.2 W
Speaker impedance
min. 4 Ω
Output voltage of
Line out
(depending on mobile device)
0.2 V AC
