01/12/14
Manuale Uso GALVALINK_302B_v3_14 EN Completo
29
Each program can be modified by the operator based on the intended work to execute. To change a
program, select using KEYS 1 and 2, confirm with KEY 4, set the desired data using KEYS 1 and 2, confirm
entry KEY 4, exit with KEY 3.
5.
TEMPERATURE/MIXER
From the display in
Fig.1
, selecting FIELD 4 TEMPERATURE/MIXER the display in
Fig. 6
appears.
Fig.6
From here you can change the working temperature (Fig. 6-1) and the mixing speed of the liquid (Fig. 6-
2).
6.
MODE PRG T
Fig.7
Fig.7
shows the initial start-up DISPLAY of the machine if set to PRG T mode (Fig. 7-5).
1-
Clk
: indicates the ampere/minutes during the use of program S1
2-
T
: indicates the time set in the program S1 ( Fig. 5-3).
3-
C°
: indicates the actual temperature of the liquid (to set the working temperature see Fig.6.1)
4-
PRG T
: indicates the machine is set to work in PRG T mode ( Fig.4-4 ; Fig.5 )
5-
V
: indicates the machine is set to work in voltage (VOLT, Fig.2-1). If it was set to work in AMPERE,
the machine in the same position of the display would display "A".
1
2
1
2
3
4
5
6
7
8
9
Summary of Contents for GALVALINK 302B
Page 2: ...01 12 14 Manuale Uso GALVALINK_302B_v3_14 EN Completo 2 ...
Page 25: ...01 12 14 Manuale Uso GALVALINK_302B_v3_14 EN Completo 25 ANNEX 5 ELECTRICAL CIRCUIT DIAGRAM ...
Page 34: ...01 12 14 Manuale Uso GALVALINK_302B_v3_14 EN Completo 34 ...
Page 35: ...01 12 14 Manuale Uso GALVALINK_302B_v3_14 EN Completo 35 ...
