Berkeley Varitronics Systems Wi-Fi Power Analyzer, Manual

Page: 4 / 39

At the top of the Wi-Fi Power Analyzer rest the power
switch and antenna connector. The power switch is a
simple two way toggle switch. The antenna connec-
tor (middle) is an SMA Female 50 ohm. The provided
antenna easily screws and unscrews from this connec-
tor. Be sure to unscrew antenna when transporting the
Wi-Fi Power Analyzer.
LED STATUS INDICATORS
Power LED indicates when the unit is ON.
Measurement LED indicates when measuring (Bar or
Line graph screen). LED is OFF when in Select Screen
Low Battery indicates when the batteries need a charge
or replacement.
CONNECTION AND USE
Connect the AP to be tested using the supplied SMA
connection kit to the Wi-Fi Power Analyzer RF input
connector, the SMA connector on the top of the Wi-Fi
Power Analyzer. Make sure both the AP and the Wi-Fi
Power Analyzer are on If not already displayed, select
either the bar or line graph measurement. If the current
RF power indicated by the text display in the lower left
of the display is –40 dbm and never changes, check the
connection between the AP and Wi-Fi Power Analyzer.
If RF power is indicated by this portion of the display,
but no bar or line is displayed, reduce the threshold
using the Down key until the display becomes active.
BATTERY REPLACEMENT
When the battery low indicator comes on, the batteries
must be replaced or recharged. To remove the batter-
ies, disconnect the Wi-Fi Power Analyzer RF input and
turn the power switch to the off position. Hold the Wi-Fi
Power Analyzer with the bottom facing you, the SMA
RF input facing upward. Locate the tab on the battery
cover and using your finger, gently pull the tab toward
Page 3