8631AF-8032AF Upgrade Instructions
Page 5 of 6
37.
Install three or four standoffs and washers replacing the adapter mounting
screws. (Fig. 4)
Fig. 4: New RHD adapter
38.
Plug the SCSI cable end C to the existing RHD adapter (Fig. 2).
39.
Install the new RHD adapter with three or four 6-32x1/4 screws using the
mounting holes closest to the flat ribbon cable. (Fig . 4)
40.
Plug the flat ribbon SCSI cable middle connector B to the new RHD
adapter. SCSI cable end C should be plugged in to the original RHD
adapter underneath the B. The SCSI cable end A should be plugged in to
the controller (Fig. 5).
41.
Connect the Data cable from the new RHD adapter to the RHD drive (Fig.
5).
42.
Connect the DC cables from the new RHD adapter to the new RHD drive
(Fig. 5 point E).
43.
Plug the DC power harness cables into the RHD adapters.
Note:
You may carefully clip the existing DC power cable tie wraps as applicable
to enable more freedom of movement and reduce cable strain.
Fig. 5: Cables
