All Bands High Sensitivity Radio
K032
Instructions for Use
Please read and retain these instructions for future reference
v001: 01/09/21
Receiving SW Broadcasts
Stand the Telescopic Antenna (1) vertically for better reception.
TROUBLE SHOOTING
The radio reception is not very good.
•
Rotate the radio or place it in a different location for best reception.
•
Adjust and extend the FM aerial.
•
For SW reception, place the antenna in an upright position.
The sound of the radio is very distorted and the volume very low
•
The batteries may be exhausted replace them as soon as possible.
The radio keeps drifting off the Band selected.
•
Check the connections between the DC Cable pin and DC input Jack (5) and mains plug and socket.
•
Check the connections between the AC mains cable figure-of-8 plug (13) and mains plug and socket.
•
Check the batteries are not discharged and have been inserted correctly check the polarities (+/-).
•
Check the unit has been switched on, the LED KNOB backlight (10) should light up.
I cannot get any reception from AIR/MB
The radio can only pick up AIR/MARINE band signals in your line-of-sight. Make sure you can see a
plane/ship that may be transmitting at the moment you are tuning in.
CAUTIONS
1.
Avoid dropping the unit.
2.
Avoid sharp knocks to the radio.
3.
Do not place the radio in a place where it is exposed to
extreme sunshine, heat, or humidity.
4.
Do not use alcohol, thinners, or other strong detergents to
clean the radio.
5.
To clean the cabinet use a soft cloth slightly dampened with a
solution of water and mild detergent.
6.
Do not allow water to drip into the cabinet.
7.
It is recommended that as soon as the sound becomes faint
or distorted, the batteries are replaced.
8.
Do not mix new batteries with old ones, or batteries of
different brands, or alkaline with rechargeable ones.
9.
If the unit is not going to be used for a long period of time,
remove the batteries to avoid any damage caused to the
radio by battery leakage and corrosion.
10.
No user serviceable parts inside the radio.
11.
Leave servicing to qualified service personnel and
technicians.