66
Problems
Prompt
password error
When using
external power
supply, the
camera can't
work normally
The camera work
abnormally and
the function is
disordered
The camera
can't shoot
automatically
Cannot switch to
"Video" or "Photo
+ Video" mode
Other problems
Camera damage
Potential cause
Forget the password
Poor power contact
External power voltage errorr
External power current is not
enough
Users incorrectly set the parameters
The PIR sensor is not working when
the camera is on the time lapse
function
The time lapse function is on
The camera can be turned on, but
there are other abnormal problems
Solutions
Enter the super password "1111" into the camera, then
you can set and remember the new password, or you
can turn it off. If the super password also fails, please
contact the dealer
Check the interfaces to ensure that they are firmly
connected
Replace the qualified external power supply.
Requirement: output voltage DC 6V (+5% or -5%),
output current is greater than or equal to 2A.
The camera cannot work under too low voltage,
but over voltage will damage the camera
Replace the correct external power adapter,
output current≥2A, lower than 2A, the camera can
not work
Set it correctly. If don't know how to set it, users
can restore the camera's default settings and reboot.
See this manual for details
Turn off the time lapse function. If don't know how
to set it, users can restore the camera's default
settings and reboot. See this manual for details
Turn off the time lapse function. If don't know how
to set it, users can restore the camera's default
settings and reboot. See this manual for details
Try the following ways:
1. Replace the batteries with enough power.
2. Replace the qualified memory card and use the ca-
mera format it.
3. Restore the camera to the default setting and restart
If the above method cannot solve the problem, the camera may be damaged, please contact
the dealer
