Beretta Power Plus Box 1001 EXT, Installation Manual

Page: 9 / 40

9
4 INSTALLATION
b
Power Plus Box 1001 heating units must be installed
in conformity to the latest provisions of the law
and standards in force concerning heating units,
condensing boilers and/or other applicable regulatory
provisions.
4 .1 Product packaging and
identification
The
Power Plus Box 1001
heating unit is supplied, packed
and protected by a strapped carton.
Figure 6
1 Boiler
2
Control panel
3
EC marking/Symbol cartouche
4
Packaging
5 Polyester corners
6
Polyester protection panel
7
Strap
Details of the product are written on the outside: model,
power, version and type of fuel. Contact your local dealer
in case of any differences with the order.
Ensure the goods are intact and complete after unpacking
them.
b
Do not leave the packaging within the reach of
children as it could be a potential source of danger.
The tag on the front side of the boiler’s electrical board,
contains the following information:
- Product name
- Serial number
- Product identification code
- CE certification number
- Gas type and pressures from mains
- Power type from mains
- Rated heat capacity (Qn)
- Rated working power (Pn)
- Efficiency according to 92/42/EEC Directive
(η)
- Max pressure and temperature (Pms)
- Primary system (T)
- NOx class (NOx)
Figure 7
a
It is forbidden to remove or mishandle the identification
plates, markings and any other making it difficult to
safely identify the product.
CONNECTION DIMENSION CONNECTION
TYPE
REMARKS
Water
distribution
2” Threaded
Flow/return
connections
for hot water,
high/low
temperature
systems
Gas fitting 1” Threaded
Exhaust flue
duct
Ø110 Socked
Piping in
plastic
material
allowed
Condensate
outlet
50 mm Socked
See
paragraph
4.1.8
4 .2 Installation premises
The heating unit must be installed in premises used
exclusively for the latter conforming to standards and
legislation in force and where combustion exhaust
products and combustion air intake is conveyed out of said
premises. Where combustion air is instead taken from the
installation premises then the latter must be equipped with
suitably sized vents conforming to standards.