7
Unpacking the product
UNPACKING THE PRODUCT
The solar collectors are packed in various ways depending
on the number of units supplied:
A
Packages of 1 or 2 collectors
B
Packages of 7 collectors
Pallet contents:
- collector
- document envelopes containing instruction manual,
bar code labels and data label.
b
Take care not to lose the four flat seal rings (1) located
in the corner profiles of each collector.
b
The instruction manual is an integral part of the solar
connector. Once located, read it thoroughly and keep
it safe.
b
STORE IN A DRY PLACE AND DO NOT EXPOSE TO DI-
RECT SUNLIGHT UNTIL THE TIME OF INSTALLATION!
The packaging is not designed to protect the prod-
uct against rain or humidity. It can also degrade if ex-
posed to direct sunlight. Failure to comply with these
precautions could lead to irreparable damage to the
product.
b
A protective film is applied to the glass of the solar col-
lector. On completion of installation, only remove this
film if you are going to put the system into service im-
mediately.
A
B
1
1
Handling
HANDLING
- Remove the PVC wrapping to free the solar collector
from the pallet.
- Apply the data label (provided in the document enve-
lope) to the back of the solar collector
Once you have removed the outer packaging, proceed as
follows to unpack and handle the solar collector:
- Tilt the solar collector slightly and grip it at the four
points shown (A) to lift it.
- Use a hoist or other suitable lifting equipment to hoist
the solar collector on to the roof.
b
Wear suitable personal protective equipment and use
suitable safety devices.
a
Do not dispose of packaging material into the envi-
ronment, or leave it within the reach of children, since
it can become a potential hazard. Dispose of packag-
ing material in compliance with applicable legislation.
a
Do not lift the solar collector by its water fittings.
Data label
A
A
A
A
Codice . . . . . . . .
Modello . . . . . . .
Matricola . . . . . .
Tipo . . . . . . . . . . . . . . . . . . . . . . .
Codice . . . . . . . . . . . . . . . . . . . . .
Dimensioni. . . . . . . . . . . . . . . . . .
Superficie lorda . . . . . . . . . . . . . .
Superficie di apertura . . . . . . . . .
Superficie assorbitore . . . . . . . . .
Peso a vuoto . . . . . . . . . . . . . . . .
Massima pressione di esercizio .
Temperatura di stagnazione . . . .
Contenuto liquido . . . . . . . . . . . .
COLLETTORE SOLARE (neutro)
Massima concentrazione glicole .
FABBRICATO IN ITALIA da Riello S.p.A.
Liquido termovettore . . . . . . . . . .
COLLB1_IT
