Bercomac 700968-1-33V, Owner'S Manual

Page: 24 / 60

Troubleshooting
22
PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION
Not the original shear bolts Always replace the shear bolts with
an original bolt.
Imperfections in the pulleys Verify if the pulleys are damaged.
Verify that the pulleys are smooth
without rust spots. Sand down the
pulleys or replace them.
Interference Make sure that the belt does not
come into contact with any other
part, bolts, guides etc… when
engaged.
Chute rotation is difficult
Dirt or ice may be underneath
chute. Dismount chute. Clean the base of
chute and the rotation ring. Lubricate
& re-install.
Chute plugs easily.
Snowblower engine running too
slowly. Run engine at full R.P.M. during snow
blowing operation.
Advancing too quickly with vehicle. Reduce vehicle’s speed..
Allow snowblower to ingest snow at
its own speed.
The engine does not start
The emergency button is pushed
down. The emergency button must be
pulled up to start the engine of the
snowblower.
The electromagnetic clutch is
activated. Deactivate the electromagnetic
clutch.
Other reasons. See engine ’s owner’s manual
Electric chute motor does not work.
Overheating of the motor. These motors are equipped with an
internal protector. Wait 10 minutes
before using.