6
ASSEMBLY
STEP 1
SNOWBLOWER PREPARATION:
Install the hand guard (item 1) in the chute (item 2) as
shown.
Secure in place with two 1/4 x 3/4" hex bolts, two flat
washers and two 1/4’’ flange nuts on the inside.
Tighten firmly.
Install chute
Install hand guard
Before installing the chute (item 1), loosen the two
flange nuts (item 2) (down to the last threads) which
holds the rotation system (item 3).
Install the rotation ring (item 4) over opening (item 5)
as shown and align the notches.
Place the chute (item 1) (facing the rear) and clip the
back over the rotation ring then turn the chute
towards the front to lock into place.
Reinstall the rotation system by tightening the flange
nuts firmly.
