5
ASSEMBLY
Tractors with an electric clutch:
Remove the anti-rotation support (item 1).
For tractors with a manual clutch:
There are no modifications to be done on the tractor
frame.
Install the left support (item 1) on the tractor frame
using four 5/16 x 3/4” hex bolts (item 2) and flange
nuts. Do not tighten yet.
Install the rotation handle support (item 3) on the
support (item 1) using two 5/16 X 3/4” hex bolts (item
2) and flange nuts. Tighten securely.
Install the plastic grommet (item 4) in the handle
support (item 3).
Slide the nylon bearing (item 4) on the lift arm (item
1), the flange first, completely to the fork (item 3).
Insert the support (item 2) onto the arm, the welded
stopper in first.
Slide the support onto the bearing and slide the
complete assembly right to the fork (item 3).
Install the right support on lift arm
STEP 1
SUBFRAME INSTALLATION:
NOTE:
You can install this subframe with or without
the mower on tractor. The mower must be removed in
order to mount the drive mechanism.
9
WARNING
9
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Remove the anti-rotation support
IMPORTANT: TORQUE ALL BOLTS ACCORDING
TO TORQUE SPECIFICATION TABLE (SEE TABLE
OF CONTENTS) WHEN STATED: TIGHTEN
FIRMLY. REFER TO PARTS BREAKDOWN
SECTION FOR THEIR IDENTIFICATION.
Install the left support
