10
Installation
6004347_0 – 27.09.2018
3.5
Installation procedure
Short overview:
1. Preparation for installation
2. Unpack the device
3. Removing the lower section, bulging edge and
4. Hang the device in place
5. Connect accessories
6. Fit chimney side parts
7. Install filter (with recirculating and hybrid operation)
8. Connect exhaust air ducting (with exhausted air and
9. Establish electrical power supply
10. Fit chimney front panel
11. Insert the Capillar Trap, bulging edge and lower section
12. Check and carry out commissioning
3.5.1
Preparation for installation
☞
Familiarise yourself with the installation situation and the
associated documents.
y
Device and instructions.
y
Accessories.
y
Installation location.
y
Intended operating mode.
☞
Assemble the tools and materials required:
y
Stable stepladder
y
Folding rule or measuring tape
y
Pencil
y
Spirit level
y
Phillips head screwdriver, size 2
y
Slotted screwdriver SL 2.5 x 0.4
y
Ø 8 mm masonry bit
y
Hammer drill
y
10 mm spanner
y
Protective material (e.g. thick cardboard) for the hob
and the worktops
☞
Keep the installation area free of objects that could be in
the way or that could be damaged.
☞
Make sure that the hob and other parts that could be
touched have cooled down.
☞
Protect the hob and other surfaces in the installation area
(e.g. with thick cardboard).
☞
Ensure that the power supply is switched off and remains
so. Connect the power supply only when instructed to do
so in the installation instructions.
If accessories (e.g. wall box, window contact switch) are
required for the installation:
Observe the instructions for the accessories.
☞
Ensure that the accessories are correctly installed and
ready for connection.
☞
Ensure that the connection cables from accessories are
correctly routed and accessible.
3.5.2
Unpack the device
D
ATTENTION!
Hazard of glass breaking or other damage due to
incorrect handling!
The device and its surfaces can be damaged when being
unpacked or transported.
☞
Do not cut into the protective cardboard packaging.
☞
Keep objects that could scratch the device far away from
it (e.g. tools, belt buckles).
☞
Unpack the device and all accompanying parts carefully.
☞
Place the device on its back on a firm, clean and
protective surface (e.g. thick cardboard).
☞
Check the device and its constituent parts for damage.
☞
Check the delivery is complete.
D
“2.4 Scope of delivery” (page 6).
If parts are missing or damaged:
☞
Please consult your dealer or customer services.
☞
Remove the packaging material.
D
Summary of Contents for Emotionline BWH 120 EL
Page 34: ...34 6004347_0 27 09 2018 ...
Page 35: ...35 6004347_0 27 09 2018 ...
Page 36: ...6004347_0 27 09 2018 ...
