8
9
EN
Operation
Remove the bottom shell by pulling it downward; then remove the
tank by turning it clockwise and paying attention not to drop the
cotton filter and the small spring found at its bottom. Pour the solu
tion to be nebulized, taking care to avoid possible spilling of liquid.
Attention: the solution to be nebulized must be water-
based; oily based solutions (e.g. gel, fragrance oil, etc.)
cannot be atomized, and can cause the clogging of the
atomizer.
Place the tank back into the main unit, and fix it by turning it
counterclockwise. Put the bottom shell back in place.
To operate the device, press the ON/OFF switch:
keep the ON/OFF switch pressed for approx. 23 seconds, the LED
light will turn green, and the device will enter induction mode: nebu
lization will activate only when hands or objects to be sanitized will
approach the infrared sensor;
press the ON/OFF button again, the LED light flashes green, red
and yellow, and the device will enter continuous mode: nebulization
is continuous, and will automatically stop after about 15 seconds;
once finished, the device goes back to induction mode;
press the ON/OFF button again, the LED light turns green, and the
device enters induction mode again.
Tu turn the device off, keep the ON/OFF switch pressed for approx.
23 seconds, until the LED light turns off.
Cleaning and maintenance
Disconnect the USB cable from the device before proceeding with
cleaning.
Clean the tank by rinsing it under tap water, dry thoroughly. Use a
slightly dampened, soft cloth to remove dust and stains from the
main unit.
To replace the cotton filter, remove it from its lodging, making sure
not to lose the small spring found at its bottom; replace with new
filter, put the small spring back in place at the bottom of filter, and
insert inside the tank.
