10
Cyclonic Vacuum Cleaner Use instructions
COMPONENTS
1. Handle
2. Hanging hole
3. Power cord winding hook
4. On/Off switch
5. Electric motor
6. Dust container
7. Hepa filter
8. Floor brush
HOW TO OPERATER YOUR VACUUM CLEANER
1. Hold the vacuum cleaner firmly with your hand on the
handle. Open the dust cup to see whether the filter is
good.
2. Push the ON/OFF Power Switch to “ON” position.
3. Start vacuuming.
CAUTION: Make sure that you hold vacuum cleaner
firmly. otherwise it can slip out of you hand and cause
injury.
CLEANING
The filters are subject to a natural deposit of dirt which decreases the suction considerably. It is
important to keep them clean in order to improve the efficiency and the life of the vacuum cleaner.
Before doing the following operations, be sure that the vacuum cleaner is turned off (the switch is
pushed into the “0” position) and that the power cord is unplug from the oulet.
When the dust container is full, please empty it.
NB.
Use compressed air (compressor or specific air cylinder) in order to clean the Hepa filter. It is advi-
sable to substitute the old filter for a new one at least once a year.
Hold the open button of the dust container in order to open and close it.
Wash the dust container with warm water and then dry it completely, before replacing it inside the
device.
WARNING:
Do not put the dust container inside the device if it is still wet.
If there is a continuous suction of large objects (for example, animal hair, buttons etc.), it is advisable
to remove the filter cover in order to allow a better air passage (Fig. C).
TECHNICAL SPECIFICATIONS
Power consumption: 600W
Power supply: 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
