Beper 40.931, Use Instructions

Page: 6 / 36

Automatic soap dispenser Use instructions
6
Safety instructions
Please read these instructions carefully when using the appliance, to
avoid damage caused by improper use.
Keep these instructions as they can be used in future situations.
If the appliance is transferred to a third party, please include these
instructions with the unit.
Do not attempt to open the container under any circumstances and
do not attempt to repair the appliance by yourself, please consult a
specialist.
Product description Fig. A
1. Top cover
2. Liquid soap insertion hole
3. ON/OFF and distribution adjustment button
4. Liquid soap nozzle
5. Dispenser body
6. Operating light
7. Battery compartment
8. Support base
Fastening procedure Fig. B
Instructions for Use
Insert the batteries into the battery compartment as described in the section “Installing the batteries”.
Unscrew the top cover and insert the liquid soap being careful not to fill more than 3/4. It is important that the
soap does not contain lumps or solid parts.
Press the ON/OFF button for a few seconds until the power light turns red.
Put your hands under the soap nozzle, the light will start to flash and the soap will start to drop, in the selected
quantity (see “adjusting the distribution quantity”).
During normal operation, press the ON/OFF button for a few seconds until the light turns off, and the sensor is
turned off.
It is not necessary to turn off the product every time. Steady red light indicates that the product is operating.
Adjusting distribution quantity
This article has three different distribution settings, you can set it according to your needs. With the product
on, press the ON/OFF button if the operating light flashes twice, it means that the minimum distribution is set.
Press the ON/OFF button again and when the light flashes three times, it means that the average distribution
has been set, press the button again, the light flashes four times, this means that the maximum distribution has
been selected. If you press the button again, the light will flash twice, this means that you return to the minimum
distribution setting.
Battery installation
Remove the support base.
Open the battery compartment and insert the batteries.
Insert 4 “AAA” type batteries and make sure to respect the polarity (+ / _).
Never mix batteries that have different characteristics or of different types.
Attention: replace all batteries at the same time.
Close the battery compartment and place back the support base.
If you do not intend to use the appliance for a long period, please remove all the batteries from the battery com-
partment.