11 INSTRUCTION MANUAL
BASIC PRINCIPLES OF WORKING WITH A MEAT GRINDER
The meat grinder is designed for processing meat without bones only at home.
Assemble the device and place it on a flat, dry surface.
Make sure that the air vents on the housing are not blocked.
Plug the power cord into an electrical outlet.
Place suitable dishes under the grinder head.
Make sure that the meat is completely thawed, remove excess fat and bones, and cut the meat
into cubes or strips so that they pass freely into the opening of the tray.
Turn the device on by setting the switch to the «ON» position.
Slowly push the meat into the mouth of the meat grinder head using the pusher. During
operation, use the push rod that is included in the delivery.
It is forbidden to use any objects to push the meat, in any case do not push the meat with your
hands.
Do not use excessive force to push through meat or other products.
During chopping meat can form a deadlock, to resolve the resulting deadlock should use the
reverse rotation of the screw.
Reverse screw rotation mode turns off the grinder by setting the switch to the "0" position,
then press and hold the switch to the «R» position.
The continuous operation time of the product processing device must not exceed 10 minutes.
After 10 minutes of continuous operation, turn off the device and allow it to cool for 15-20
minutes, after which you can continue working.
As soon as you finish working, turn off the meat grinder by setting the switch to the "0"
position, disconnect the meat grinder from the power supply, and only then start disassembling
it.
PREPARATION FOR WORK
The device is intended for preparing minced meat.
Wash all parts of the meat grinder that will come into contact with food (except the body) with
warm water and detergent.
Before connecting the appliance to the mains, make sure that it is switched off.
Assembly
Place the meat grinder on a flat, horizontal surface.
Press the attachment button, attach the set-top box to the
electric drive (when inserting the set-top box, note that it is
tilted according to the arrow shown at the top in figure 1, then
turn the screw clockwise so that it is firmly fixed (figure 2).
Insert the screw into the console and turn it all the way around,
until it is fixed in the motor hole (Fig. 3).
Insert the knife into the screw slot with the cutting edges facing
the grate (Fig. 4). If the knife is installed incorrectly, the meat
will not be ground.
Insert the grate you selected in the track of the knife into the
screw slot in the special connector (Fig. 5).
Tighten the nut while holding the grate with the knife with one
hand (Fig. 6).
Place the tray on the set-top box and lock it.
