29
Bentone
7.1.2 Replacement of pump filter
Removal and installation
1. Close the oil supply to the burner
2. Loosen the pump cover’s screws.
3. Remove the filter and gasket
4. Mount new gasket and filter
5. Refit the cover
6. Open the oil supply
7. Start the burner and check seals and combustion
!
Use caution when operating the burner, surfaces
may be hot.
!
When servicing oil bearing components, check for
oil leakage when the burner is commissioned after
servicing.
7.1.3 Check oil line seals
Once the burner has been installed and commissioned, the seals of the
various coupling elements should be checked.
When a leak is detected, it is usually sufficient to tighten the coupling
element that is leaking.
8
7
5
4
3
12
10
7
8
11
10
7
8
Filter
Gasket
Note:
*
When servicing/replacing components that affect combustion, an
analysis and soot test shall be carried out on the installation.
Summary of Contents for B 30 A2.2H
Page 2: ...2 Bentone...
Page 38: ......
Page 39: ......
Page 40: ...Enertech AB P O Box 309 SE 341 26 Ljungby www bentone se www bentone com...
