Bentone 650004465601, Installation And Maintenance Instruction

Page: 27 / 44

27
Bentone
!
Use caution when operating the burner, surfaces
may be hot.
! When servicing oil bearing components, check the
oil density when the burner is commissioned after
servicing.
J K
6.4 Replacement of oil pump
Removal and installation
1. Turn off the main power switch and disconnect the Eurostecker
connectors from the burner.
2. Disconnect the oil hoses from the pump.
3. Undo the screws (J) and pull out the oil pump.
4. Measure the distance between the pump mounting and the pump
coupling (K).
5. Transfer the pump coupling to the new pump and adjust to give the
same spacing between the pump and pump coupling as before (K).
6. Fit the oil pump on the burner and tighten the screws (J). (It is
important that splines on the pump shaft align correctly with the pump
coupling.)
7. Fit the oil hoses.
8. Connect the Eurostecker connectors and turn on the main power
switch.
9. Bleed the pump, start the burner and adjust to the correct oil pressure.
10. Check combustion.
!
If the burner is directly connected, ensure that all
components on the burner are without power.
165 205 36 2020-11-02/4
!
When servicing/replacing components that affect combustion, an analysis and
soot test must be carried out on the installation.