![background image](http://html.mh-extra.com/html/benq/w1400/w1400_user-manual_2733761026.webp)
26
Important safety instructions
Adjusting the projected image
Adjusting the projection angle
There are four adjuster feet on the bottom of the
projector. These can be used if necessary to change the
projection angle. Screw the feet in or out as appropriate to
aim and level the projection angle.
If the screen and the projector are not perpendicular to each
other, the projected image becomes vertical trapezoidal. To
correct this problem, see
"Correcting picture distortion" on
for details.
Correcting picture distortion
Keystoning occurs when the projector is not perpendicular to the screen and is where the projected
picture displays visible as a trapezoid shape like either of the following:
• Two parallel sides (left and right, or top and bottom) but is noticeably wider on either side.
• No parallel sides.
To correct the picture’s shape, you can perform the following steps.
1. Adjust the projection angle. Move the projector to be in front of the center of the screen with the
center of the lens level with the screen.
2. If the picture is stilled distorted, or the projector is unable to be positioned as described above, you
will need to manually correct the picture.
• Using the remote control or projector
i. Press one of the Arrow/Keystone keys on the remote control or projector (Up / , Down /
) to display the Keystone page.
below for further operation.
• Using the OSD menu
i. Press
MENU/EXIT
and then press / until the
Display
menu is highlighted.
ii. Press
to
highlight
Keystone
and press
MODE/ENTER
. The keystone correction page
displays.
iii. Press the key whose keystone icon is opposite to the shape of the projected picture. Continue
pressing the same key or press the other keys until you are satisfied with the shape.
The values on the lower portion of the page change while pressing. When the values reach their
maximum or minimum with repeated key presses, the picture’s shape will stop changing. You will
not be able to change the picture further in that direction.
Press
/
.
Press
/
.