![background image](http://html.mh-extra.com/html/benq/w1300/w1300_user-manual_2735041035.webp)
Operation
35
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
You can also manually cycle through the
available input signals.
1.
Press
SOURCE
on the projector or
press input source directly from the
remote control. A source selection bar
displays.
2.
Press /
until your desired signal is
selected and press
MODE/ENTER
.
Once detected, the selected source
information will display on the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps
1-2 to search for another signal.
•
The brightness level of the projected image will change accordingly when you switch
between different input signals. Data (graphic) "PC" presentations using mostly static
images are generally brighter than "Video" using mostly moving images (movies).
•
The native display resolution of this projector is in a 16:9 aspect ratio. For best display
picture results, you should select and use an input signal which outputs at this resolution.
Any other resolutions will be scaled by the projector depending upon the 'aspect ratio'
setting, which may cause some image distortion or loss of picture clarity. See
"Selecting the
aspect ratio" on page 43
for details.
You can also rename the source:
1.
Press
MENU/EXIT
and then press
/ until the
System Setup: Basic
menu is
highlighted.
2.
Press
to
highlight
Source Rename
and press
MODE/ENTER
. The
Source
Rename
page
displays.
3.
Press /
/ /
until your desired character is selected and press
MODE/ENTER
.
• If you want the projector to automatically search for the signals, select
On
in the
System Setup: Basic
>
Auto Source Search
menu.
HDMI 1
HDMI 2
VIDEO
PC
COMPONENT
BenQ W1300.book Page 35 Thursday, August 29, 2013 2:07 PM