BenQ PM096B00, Installation Manual

Page: 9 / 20

2013/7/25 8
Chapter 3 Chapter 3 Chapter 3 Chapter 3 Mo Mo Mo Mounting unting unting unting Guidelines Guidelines Guidelines Guidelines
Modules may be mounted at any angle from horizontal to vertical. Select the appropriate
orientation to maximize sunlight exposure.
A gap between the module and system structure or ground is required to prevent wire
damage and to allow air to circulate behind the module.
Take care to follow all applicable regulations, especially municipal and fire codes, when
planning and executing your installation. Do not remove or alter the module frame.
Additional mounting holes may damage the module and reduce the strength of the frame.
IMPORTANT IMPORTANT IMPORTANT IMPORTANT
Modules should
Modules should Modules should
Modules should only
only only
only be mounted u
be mounted u be mounted u
be mounted using
sing sing
sing one of
one of one of
one of the following methods
the following methods the following methods
the following methods.... Deviating from the
Deviating from the Deviating from the
Deviating from the
mounting instructions below mounting instructions below mounting instructions below mounting instructions below could could could could affect max wind load and/or product warranty. affect max wind load and/or product warranty. affect max wind load and/or product warranty. affect max wind load and/or product warranty.
3.1 Mounting with Screws
•
Secure the module to the structure using only the factory drilled mounting holes.
•
Do not drill any additional holes in module frame (doing so would void the warranty).
•
Use corrosion-proof fastening materials.
•
A torque wrench must be used for assembly. In the examples shown, the tightening
torque must be 20N
．
m.
•
Refer to product datasheet for the module dimensions and mounting hole locations.
PM200M00 / PM245P00 / PM250M01 / PM300P00
PM200M00 / PM245P00 / PM250M01 / PM300P00 PM200M00 / PM245P00 / PM250M01 / PM300P00
PM200M00 / PM245P00 / PM250M01 / PM300P00
Secure the modules to the structure using four stainless steel bolts, with nuts, washers, and
lock washers. Only the existing mounting holes (Diameter: 9mm
9mm 9mm
9mm) that can be used for module
to meet 5400Pa design strength under IEC 61215/ IEC 61730 and to meet 2400Pa design
strength under UL 1703.
PM318B00 PM318B00 PM318B00 PM318B00 //// PM318B01 PM318B01 PM318B01 PM318B01 //// PM096B00 PM096B00 PM096B00 PM096B00
Secure the module to the structure using four M6 (¼”) M6 (¼”) M6 (¼”) M6 (¼”) stainless steel bolts, with nuts,
washers, and lock washers per module. Only the mounting holes that are 322mm from the
short end of the module can be used for the module to meet 5400 Pa design strength.