![background image](http://html1.mh-extra.com/html/benq/mw826sth/mw826sth_user-manual_2734800023.webp)
23
Operation
Controlling the projector through a Wired LAN
environment
Wired LAN allows you to manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other
end to the RJ45 port.
2. Make sure the menu type is
Advanced
. See
for how to switch to the
Advanced
OSD menu.
3. Go to
Advanced
-
Network
.
4. Highlight
Wired LAN
and then press
OK
. The
Wired LAN
page is displayed.
5. Press
/
to highlight
DHCP
and press / to select
On
.
6. Press
/
to highlight
Apply
and press
OK
.
7. Go back to the
Network
page.
8. Press
/
to highlight
AMX Device Discovery
and press / to select
On
or
Off
. When
AMX Device Discovery
is
On
, the projector can be detected by AMX controller.
9. Please wait for around 15 - 20 seconds, and then re-enter the
Wired LAN
page.
10. The
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings will be displayed.
Note down the IP address displayed in the
IP Address
row.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
/
to highlight
DHCP
and press / to select
Off
.
3. Contact your ITS administrator for information on the
IP Address
,
Subnet Mask
,
Default
Gateway
, and
DNS Server
settings.
4. Press
/
to select the item you want to modify and press
OK
.
5. Press / to move the cursor and then press
/
to enter the value.
6. To save the setting, press
OK
. If you do not want to save the setting, press
BACK
.
7. Press
BACK
to return to
Wired LAN
page, press
/
to highlight
AMX Device Discovery
and press / to select
On
or
Off
.
• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector’s native
resolution. Any other resolutions will be scaled by the projector depending upon the “aspect ratio” setting,
which may cause some image distortion or loss of picture clarity. See
.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or interruption.
If the
IP Address
still does not display, contact your ITS administrator.