![background image](http://html.mh-extra.com/html/benq/mw821st/mw821st_user-manual_2733741035.webp)
Operation
35
Shutting down the projector
1.
Press
POWER
and a confirmation message will display prompting you.
If you don't respond in a few seconds, the message will disappear.
2.
Press
POWER
a second time. The
POWER indicator light
flashes orange,
the projection lamp shuts down, and the fans will continue to run for approximately
90 seconds to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling process.
To shorten the cooling time, you can also activate the Quick cooling function. See
"Quick Cooling" on page 42
for details.
3.
Once the cooling process finishes, a "
Power Off
Ring Tone
" will be heard. The
POWER indicator
light
is a steady orange and fans stop. Disconnect
the power cord from the power outlet.
•
To turn off the power ring tone, see
"Turning off the Power On/
Off Ring Tone" on page 33
for details.
•
If the projector is not properly shut down, to protect the lamp,
when you attempt to re-start the projector, the fans will run for a
few minutes to cool down. Press
POWER
again to start the
projector after the fans stop and the
POWER indicator light
turns orange.
•
Lamp life results will vary depending on environmental conditions
and usage.
Direct power off
The AC power cord can be pulled out right after the projector is turned off. To protect
the lamp, wait about 10 minutes before re-starting the projector. (When you attempt to
re-start the projector, the fans may run for a few minutes to cool down. In such cases,
press
POWER again to start the projector after the fans stop and the POWER indicator
light turns orange.