![background image](http://html1.mh-extra.com/html/benq/ms614/ms614_user-manual_2734742018.webp)
Operation
18
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1 quick-release adjuster foot and 1 rear adjuster foot. These
adjusters change the image height and projection angle. To adjust the projector:
1.
Press the quick-release button and lift the front
of the projector. Once the image is positioned
where you want it, release the quick-release
button to lock the foot in position.
2.
Screw the rear adjuster foot to fine-tune the
horizontal angle.
To retract the foot, hold up the projector while
pressing the quick-release button, then slowly lower
the projector. Screw the rear adjuster foot in a reverse
direction.
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes trapezoidal.
To correct this situation, see
"Switching input signal"
on page 24
for details.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on the
projector or remote control. Within 3 seconds, the built-in Intelligent Auto Adjustment
function will re-adjust the values of Frequency and Clock to provide the best picture quality.
The current source information will be displayed in the corner of the screen for 3 seconds.
•
The screen will be blank while AUTO is functioning.
•
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
2
1
Do not look into the lens while
the lamp is on. The strong light
from the lamp may cause
damage to your eyes.
Be careful when you press the
quick-release button as it is
close to the exhaust vent where
hot air comes from.
1.
Adjust the projected image to the size
that you need using the zoom ring.
2.
Sharpen the image by rotating the
focus ring.