Operation
39
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speakers. Be sure
you have made a correct connection to the projector audio input. See
"Connection" on page
18
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.
Press MENU/EXIT and then press /
until the SYSTEM SETUP: Advanced menu
is highlighted.
2.
Press to highlight Audio Settings and press MODE/ENTER. The Audio Settings
page displays.
3.
Highlight Mute and press /
to select On.
Adjusting the sound level
To adjust the sound level, press /- on the remote control, or:
1.
Repeat steps 1-2 above.
2.
Press to highlight Volume and press /
to select a desired
sound level.
Turning off the Power on/off ring tone
To turn off the ring tone:
1.
Repeat steps 1-2 above.
2.
Press to highlight Power on/off ring tone and press /
to
select Off.
The only way to change Power on/off ring tone is setting On or Off here.
Setting the sound mute or changing the sound level will not affect the
Power on/off ring tone.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu Display Time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use
/
to select a suitable time.
• Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use
/
to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On-
Screen (OSD) Menus. Use
/
to select your language.
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use
/
to select a screen.