BenQ M2700HD, Service Manual, Page: 12 / 53

BenQ M2700HD Service Manual
11
Net Weight (Kg)
Gross
Weight(Kg) Dimension w/o Base
LxWxH (mm) Dimension w/ Base
LxWxH (mm)
4.9±0.3 Kg ( Net) 6.1±0.3Kg 512.39x348.35x99.63mm
512.39x348.35x163.35
mm
Package:
Carton Interior Dimension (mm)
LxWxH Carton External Dimension (mm)
LxWxH
760X578X280mm 774X592X310mm
4 .Cosmetic / Appearance / Alignment Service
4.1 Software / Firmware Upgrade Process
Upload firmware to MCU via VGA Cable
1. Connect ISP board between monitor and PC as below configuration.
2. Press the “connect” button in ISP.exe, and press “Read” button to load BIN file, then press “Auto”
button to enter ISP page, finally, press “Run” Icon to start ISP.
3. Waiting for “PASS”, then please plug out power cable and re-start monitor again.
4.2 Alignment procedure (for function adjustment)
4.2.1 Preparation:
1. Setup input timing VESA to 1920*1080@60Hz,32-Grays pattern.
2. Setup units and keep it warm up for at least 30 minutes.
4.2.2 Timing adjustment
1. Enter to factory mode setting area (by pressing “ENTER”+ “MENU” + “POWER” at the same time during
power off).
2. Check the settings to following values:
Contrast
=50;
Brightness=100;
Color
enhancement=general;
3. Then turn off the monitor power.
4.2.3 Function key Definitions
4.2.3.1 Control buttons on the rear side of monitor
CONTROL KEY KEYS FUNCTION
Insert to
Parallel Port on
PC
ISP Board
LCD
Monitor
D-Sub
Parallel Port
D-SUB 15PIN