39
Menu Functions
System Setup : Advanced
menu
Submenu
Functions and Descriptions
Lamp Settings
• Reset Lamp Timer
Activate this function only after a new lamp is installed. When you select
Reset
,
a "
Reset Successfully
" message is displayed to notify that the lamp time has
been reset to "0".
• Lamp
Timer
Select to learn the duration (in hours) of lamp usage which is automatically
calculated by the built-in timer.
Total (equivalent) lamp hour = 2.0 x (hours used in
Normal
mode) + 1.4 x
(hours used in
Economic
mode) + 1.0 x (hours used in
SmartEco
mode)
HDMI Settings
•
HDMI Range
Selects a suitable RGB color range to correct the color accuracy.
•
Auto
: Automatically selects a suitable color range for the incoming
HDMI signal.
•
Full
: Utilizes the Full range RGB 0-255.
•
Limited
: Utilizes the Limited range RGB 16-235.
HDMI Range is only available when the HDMI signal is selected.
•
CEC
When you connect an HDMI CEC-compatible device to your projector with an
HDMI cable, turning on the HDMI CEC compatible device automatically turns
on the projector, while turning off the projector automatically turns off the
HDMI CEC compatible device. You can use the projector’s remote control to
control your HDMI CEC-compatible devices. See item 17 on page
for
details.
•
Power On Link
/
Power Off Link
When you connect an HDMI CEC-compatible device to your projector with an
HDMI cable, you can set the behavior of powering on/off between the device
and the projector.
Baud Rate
Select a baud rate that is identical with your computer’s so that you can connect
the projector with a suitable RS-232 cable and update or download the
projector’s firmware. This function is intended for qualified service personnel.
Test Pattern
Enable this function to display the grid test pattern, which helps you adjust the
image size and focus so as to check if the projected image is free of distortion.
Quick Cooling
Select
On
to shorten the projector cooling time from a normal 90-second
duration to approximately 15 seconds.
Bidirectional
Turning on/off either the connected device or the
projector can turn on/off both.
From Projector
When the projector is turned on/off, the connected
device will be activated/shut down, too.
From Device
When the connected device is turned on/off, the
projector will be activated/shut down, too.
