![background image](http://html1.mh-extra.com/html/benq/home-entertainment-w500/home-entertainment-w500_user-manual_2734549046.webp)
46
Maintenance
English
11. Turn the power on and reset the lamp time.
i. Press MENU to open the OSD menu.
ii. Go to the Advanced Setup > Lamp Settings menu and
press ENTER.
iii. Highlight Reset Lamp Timer and press ENTER.
iv. A warning message displays asking if you want to reset
the lamp timer.
v. Highlight Reset and press ENTER to reset the lamp timer to "0".
Do not reset the lamp timer if the lamp has not been replaced as this could cause damage.
5.
Lift the handle so that it stands up. Use the handle to
slowly pull the lamp out of the projector.
• Pulling it too quickly may cause the lamp to break and
scatter broken glass in the projector. To reduce the
risk of injuries to fingers and damage to internal
components, use caution when removing lamp glass
that has shattered.
• Do not place the lamp in locations where water might
splash on it, children can reach it, near or above heat
sources, or near flammable materials.
• Do not insert your hand into the projector when the
lamp is removed. If you touch the optical components
inside, it could cause blurred images.
6.
As shown in the figure, lower the new lamp first into the
connector on the projector and align the two holes on
the lamp with the locators on the projector.
7.
Push the lamp downwards to ensure it is firmly secured
to the projector.
8.
Tighten the screws securing the lamp box.
9.
Re-install the lamp cover.
10. Tighten the screw on the lamp cover.
• Please be careful to not over-tighten the screws.
• Loose screws may cause a bad connection, which
could result in malfunction.
WARNING
Reset Lamp Timer?
Reset
Cancel